Flat Christmas Village for Tea Lights

What You'll Need

• All printed parts (ensure they're fully cooled)
• Optional: Fine sandpaper (220-400 grit)
• Optional: Primer and paint

General Assembly & Finishing Guidelines

• The entire model can be printed using a single filament color (for example, white). After printing, it is recommended to lightly sand any rough surfaces and remove possible stringing to achieve a smoother finish.

Step-by-Step Assembly

1. Add tea light tray: Slide down flat model to tray

Recommended Settings

• Layer Height: 0.12mm - 0.3mm (I printed with 0.3 with Matte filament)
• Infill: 10-15% for structural strength
• Supports: This model doesn't need supports
• Print Speed: 30-40mm/s for initial layer, then up to 150mm/s.
• Wall Count: 2-4 walls for strength
• Temperature: PLA 200-210°C, PETG 230-240°C

Material Recommendations

• PLA: but could be printed with other types (e.g. PETG)
• Colors: White
• Finish: Consider matte finish filament to reduce layer lines

Special Effects & Details

• This model is flat, I recommend gluing white baking paper on the back side, especially if you plan on adding lights. It will diffuse light for a warmer effect
• Add battery-powered tea lights (DON'T use fire)